Phoenix Inverter 24/1200 230V VE.Direct IEC

The Phoenix Inverter 24/1200 VE.Direct inverter allows you to power domestic equipment – requiring 230V – using ‘leisure’ or ‘automotive’ batteries rated at 12V, 24V or 48V DC.

This unit has the IEC plug.

Features
VE.Direct communication port

The VE.Direct port can be connected to:

A computer (VE.Direct to USB interface cable needed)

Apple and Android smartphones, tablets, MacBook’s and other devices (VE.Direct Bluetooth Smart dongle needed)

Fully Configurable:

Low battery voltage alarm trip and reset levels

Low battery voltage cut-off and restart levels

Dynamic cut-off: load dependent cut-off level

Output voltage: 210 – 245V

Frequency 50 Hz or 60 Hz

ECO mode on/off and ECO mode sense level

Monitoring

In- and output voltage, % load and alarms

Proven reliability

The full bridge plus toroidal transformer topology has proven it’s reliability over many years. The Phoenix Smart Inverters are short circuit proof and protected against overheating, whether due to overload or high ambient temperature.

High start-up power

Needed to start loads such as power converters for LED lamps, halogen lamps or electric tools.

ECO mode

When in ECO mode, the inverter will switch to standby when the loads decreases below a preset value. Once in standby the inverter will switch on for a short period every 2.5 seconds (adjustable). If the load exceeds the preset level, the inverter will remain on.

Remote on/off

A remote on/off switch or relay contact can be connected to a two pole connector. Alternatively, the H terminal (left) of the two pole connector can be switched to battery plus, or the L terminal (right) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example).

DC connection with screw terminals

No special tools needed for installation.

Monitor, operate & control over your system

VictronConnect lets you get live status information and configure your Phoenix Inverter 24/1200 VE.Direct when connected to a VE.Direct Bluetooth Smart Dongle.

The REC040010210R is the correct controller for the Phoenix Inverter VE.Directs.

Click here for Phoenix Inverter VE.Direct IEC Datasheet.

Disclaimer: Product images are for illustrative purposes only and may not be an exact representation of the products.